Menu
Cerca
Euro
Italian
Cerca Close
Shopping cart Close

Non ci sono articoli nel tuo carrello

All Categories
    Menu Close

    iRangeX IRX4 Plus 2.4G CC2500 NRF24L01 A7105 CYRF6936 4 IN 1 Multiprotocol STM32 TX Module With Case

    Venditore: Serier Electronics

    Spedizione da magazzino Europeo

    nessuna tassa doganale è richiesta per le spedizioni nel mercato UE




    Cod.: BG-1225080
    €57,12




    i h
    *
    iRangeX IRX4 Plus 2.4G CC2500 NRF24L01 A7105 CYRF6936 4 IN 1 Multiprotocol STM32 TX Module With Case
    iRangeX IRX4 Plus 2.4G CC2500 NRF24L01 A7105 CYRF6936 4 IN 1 Multiprotocol STM32 TX Module With Case

    Overview:
    This 2.4G Multi-protocol TX Module is STM32 ARM microcontroller based module. All available protocols are included in serial mode. It is suitable for many brand of quadcopters, helicopters and airplanes.
    This module integrate four RF chips (CC2500,NRF24L01,A7105,CYRF6936) into one single circuit board, it .supports a variety of remote control protocols ,such as Futaba S-FHSS, Walkera DEVO, Spektrum DSM2, DSMX, Flysky, Frsky, WLToys, Hubsan, Hisky, Esky , Assan etc. You can control your craft flexibility with it , and You will get much excellent experience with you favorite transmitter.
     
    Specification:
    Brand Name: iRangeX
    Item Name: IRX4 Plus
    Operating Voltage: 5-14V                         
    Operating Current: <=100mA    
    Operating Frequency: 2.4G ISM band               
    RF Power: +22dBm    
    MCU: STM32F103CBT6(128K ROM, 20K RAM)    
    Weight: 45g           
     
    Features:              
    Two operation modes: PPM mode and serial mode.
    - When in PPM mode, there are 31 different protocols (protocol NO.0 is reserved for serial mode) mapping to the 16-position protocol selection switch on the module. They are listed in the default protocols table below, when the green light is off, you can use the switch to choose protocol NO. 1 to NO.15, when the green light is on, you can choose protocol NO.16 to NO.31.
    - To turn on/off the green light, Please follow these steps:
      Turn off you transmitter, point the protocol switch to ‘0’, hold and press the bind button of RF module, then turn on your transmitter, after 3 seconds, release the button.
     
    Normal Use Operation in PPM Mode:
    1. Install RF Module in position, Set PPM signal output on you transmitter.
    2. According to the default protocols table, turn the arrow sign (the side with a vertical slot) of protocol switch to the proper number to choose protocol.
    3. After finish binding operation, Power on your transmitter, the red light of RF module will be on, then RF module is ready to work , after that power on your receiver (or craft).
    4. Protocol selection is done at the beginning of power up, so if you want to change protocol during operation, you should recycle the power.
    5. The red light will blink slowly if there is no valid PPM signal.
     
    Binding Operation in PPM Mode:
    1. Power on your receiver, and set it to binding mode.
    2. Hold and press the bind button of RF module, and then turn on your transmitter, after 3 seconds, release the button, you will see the red light flashing rapidly, then RF module is in binding mode, and the red light will go solid after binding.
    3. Some protocols (eg: S-FHSS) don’t have binding procedure on RF module, and some protocols (eg: hubsan, e010)will auto bind when power up.
     
    Operation in Serial Mode:
    When the green light is off, and the protocol switch is point to ‘0’, you can access serial mode. Transmitter that supports the er9X/erSky9X or Open TX firmware can work in this mode, The model protocol selection and binding is done from the Model Settings menu on the transmitter, For telemetry capable transmitters, the telemetry integration is done seamlessly with the transmitter firmware.
    For more information, Please refer to the Link below.
    https://github.com/pascallanger/DIY-Multiprotocol-TX-Module
    https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/blob/master/Protocols_Details.md
      
    Notice:
    - The jumpers and header attached is used for updating firmware of TX module through USB serial cable. Please remove them for normal use..  
    - Sometimes, you may need a power recycle when you choose a new protocol. for example, protocol changes from Q303 to HISKY.
    - For FRSKY and S-FHSS protocol, you may need set the value of Fine or Option (in the Model Settings menu) properly to bind with your model. The value is varied, since it’s partly depended on your model.
     
    Default Protocols in PPM Mode: 
    NO.DialGreen lightProtocolSub_protocolOptionRF Chip
    00OffSerial--ALL
    11OffFLYSKYFLYSKY0A7105
    22OffAFHDS2APWM_SBUS0A7105
    33OffHUBSAN-0A7105
    44OffFRSKYD-0CC2500
    55OffFRSKYXCH_80CC2500
    66OffS-FHSS-10CC2500
    77OffDSM2DSM2_227CYRF6936
    88OffDSMXDSMX_227CYRF6936
    99OffDEVO-0CYRF6936
    10AOffJ6PRO-0CYRF6936
    11BOffESKY-0NRF24L01+
    12COffHISKYHisky0NRF24L01+
    13DOffKNWLTOYS0NRF24L01+
    14EOffV2X2V2X20NRF24L01+
    15FOffASSAN-0NRF24L01+
    160OnMJXQE0100NRF24L01+
    171OnFRSKYV-0CC2500
    182OnAFHDS2APPM_IBUS0A7105
    193OnMJXQX8000NRF24L01+
    204OnYD717YD7170NRF24L01+
    215OnSYMAXSYMAX0NRF24L01+
    226OnSLT-0NRF24L01+
    237OnCX10CX10_BLUE0NRF24L01+
    248OnCG023CX100NRF24L01+
    259OnBAYANGBAYANG0NRF24L01+
    26AOnMT99XXMT990NRF24L01+
    27BOnSHENQI-0NRF24L01+
    28COnFY326FY3260NRF24L01+
    29DOnFQ777-0NRF24L01+
    30EOnHONTAIHONTAI0NRF24L01+
    31FOnQ2X2Q2220NRF24L01+
     
     
    All Available Protocols for Serial Mode:
    ProtocolSub_protocol     Auto BindOptionRF ChipReference
    FLYSKY　NO0A7105FLYSKY AFHDS
    HUBSAN　YES0A7105HUBSAN
    AFHDS2APWM_IBUSNO0A7105FLYSKY AFHDS2A
    PPM_IBUSNO0A7105
    PWM_SBUSNO0A7105
    PPM_SBUSNO0A7105
    FRSKYD　NO-10CC2500FRSKY D8
    FRSKYXCH_16NO-10CC2500FRSKY D16
    CH_8NO-10CC2500
    FRSKYV　NO-10CC2500　
    S-FHSS　NO10CC2500Futaba
    DSMDSM2_22NO6CYRF6936DSM2,22mS
    DSM2_11NO6CYRF6936DSM2,11mS
    DSMX_22NO6CYRF6936DSMX,22mS
    DSMX_11NO6CYRF6936








    Etichetta del prodotto
    Informazioni
    Profilo
    Servizio Clienti

    Payment options

    Serier® s.r.l. Via G.Marcomi 6 Offanengo 26010 (CR) p.iva : 01704390192    Powered by nopCommerce
    Copyright © 2024 Prodotti Italiani. Tutti i diritti riservati